не потерять
DSC PC 4020Performing a Walk Test
Keypad Command: [*][6][Walk Test Code]
The Walk Test feature allows you to test if the detectors on a partition are
in proper working order. There are six options in the walk test menu. To
access the walk test options, perform the following:
1. Press [*] [6] followed by the Walk Test code. If you do not know the
Walk Test code, ask your installer.
2. Use the arrow (< > keys to scroll to the walk test option you wish to
execute and press [*]. The test will begin once the [*] key is pressed.
Each test must be initiated separately by performing Steps 1 and 2. The
five test options are as follows:
•
Local Walk Talk Test (No Bell): This option will operate the same as the
Local Walk Test except that the bell will not sound when each zone
is activated.
•
Local Walk Test: When this option is selected, the keypad will sound
three quick beeps and return to the normal disarmed display. You
can then test each detector on the partition. For motion detectors,
create movement in the detected area. For door and window contacts,
open and close protected doors and windows. Any zone violated
will cause the bell or siren to sound for two seconds, confirming that
the detectors are working properly.
During walk test mode, no alarms on that partition will be
transmitted to the monitoring station. However, if a PC4400 printer
module is installed, the violated zones will be printed.
Consult each device’s manufacturer ’s instructions for proper ways
to test them.
•
Local + Communications Test: This option will operate the same as
Local Walk Test except that alarms will be transmitted to the
monitoring station in order to test communications.
•
AML Smoke Test: This option will test all AMS-220 smoke detectors
enrolled on the system. This option will also restore any troubles
which were fixed by a service technician. The test will perform itself
and will take a few minutes to complete. Once the test is finished,
the partition will return to its normal disarmed state.
•
Fire Insp. Test: This test is only to be performed by your installer or
fire inspector

про вдруг - если сработала пожарная сигнализация а у вас все впорядке, не поленитесь, пройдите по помещениям (если не знаете сработавшей зоны) и посмотрите какой из датчиков моргает красным. когда найдете заразу выкрутите и вкрутите как лампочку, система перегрузится и датчик востановится. иногда они заедают и если не восстановить во второй раз могут не сработать. если один и тот же датчик срабатывает несколько раз за короткое время - вызывайте мастера или прекратите жечь жратву уже.

upd
тот момент когда опыт пасует.
нам подключили производcтвенные помещения кораблестроительного завода фаера срабатывают постоянно. но. до датчиков не дотянуться дажев прыжке, даром что страна баскетболистов чо делать хрензнает,кроме как каждый раз мастеров звать

запись создана: 26.04.2015 в 00:17